Samsung OfficeServ 7100 Technical Manual page 571

OfficeServ 7100
TECHNICAL MANUAL
GENERAL SCREEN:
Field Name
Label Name
Line is wink start
Wait for loop current
Rings before
answer
Hunt group type
Disconnect signal
Toll saver group
Toll saver rings
Toll saver prompt
Auto clear MWI
Description
The name of this Port block
(DO NOT ADJUST)
(DO NOT ADJUST)
(DO NOT ADJUST)
This should match the ring type setting in MMC 601. If MMC 601 is
set to Sequential, this setting should be 'Linear'. If MMC 601 is set
to Distributed, this setting should be 'Rotating'
This setting is mainly provided to overcome issues with CO
disconnect signaling. In some cases, the CO does not send the
OfficeServ 7100 a proper disconnect signal, which can result in
the subscriber getting messages with dial tone or error tone at the
end. This field allows the system to look for a different type of
disconnect signal, such as dial tone or fast busy.
(DO NOT ADJUST)
(DO NOT ADJUST)
(DO NOT ADJUST)
(DO NOT ADJUST)
5.3.49
Table of Contents
Home Page
PROGRAMMING
PART 5 APRIL 2007