Samsung OfficeServ 7100 Technical Manual page 420

OfficeServ 7100
TECHNICAL MANUAL
MMC: 833
DESCRIPTION:
This MMC is used to store IP addresses and miscellaneous options relating to SIP
or H.323 Peering devices. This MMC works in conjunction with MMC 832 to allow
dialing between the OfficeServ 7100 and a SIP or H.323 device. There are 250
tables with up to 4 IP addresses each.
IP ADDR 1 ~ 4:
NOTE: When changing any IP address/value, listed below, three digits must be
input for each (octet) field.
Example 192.168.1.10 input must be: 192 168 001 010
PROTOCOL:
ALIVE CHK:
USER INFO:
RMT PORT:
CHK TIMER:
[Applies to v.4.30 or Higher]
The destination IP address is required to route dialed digits
based on the access code and digits dialed. The IP entry field is
divided into 4 sections allowing modification of separate IP
address fields.
This option determines the device type for this table of IP
addresses. The available settings are SIP (the default), and
H323.
This option determines if a keep alive test will be performed
periodically to verify the status of the devices at IP ADDR 1 ~
4. The default setting of NONE means that no alive check will
be performed. Setting this to OPTION will periodically,
according to the CHK TIMER below, send a request to the SIP
device for supported options, thus verifying the status of the
device.
Some peering devices require that calls sent to them be
prefixed with the device's extension number before the call will
be processed. By default this field is blank, but it can accept an
entry of up to 32 characters.
This option sets a 5 digit TCP/IP port number the devices in this
table will use to communicate. The default setting is 05060,
meaning communications will occur on the standard SIP port
5060. Any 5 digit port number may be used.
This option determines the time in milliseconds between keep-
alive checks if ALIVE CHK above is set to OPTION. The default
Home Page
PROGRAMMING
PART 2 MAY 2009
VoIP IP ADDRESS
Table of Contents