Samsung OfficeServ 7100 Technical Manual page 28

OfficeServ 7100
TECHNICAL MANUAL
MMC: 105
DESCRIPTION:
Allows the system administrator or technician to program the personal speed dial
locations assigned to a station. This must be done for single line telephones because
these stations cannot access programming. Each station may have up to 50
locations or bins assigned to it in MMC 606 Assign Speed Block. The speed dial bins
are numbered 00~49 (or 000~049 if the SYSTEM SPEED BIN MAX = 950 in MMC
861). Each speed dial number consists of a trunk or trunk group access code
followed by a separator and up to 24 digits to be dialed. These dialed digits may
consist of 0~9, and #. If the system recognizes a valid trunk or trunk group access
number, it will automatically insert the separator.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
B Used to insert a flash code "F"
C Used to insert a pause code "P"
D Used to insert a pulse/tone conversion code "C"
E Used to mask/unmask following digits (shows as "[" or "]")
F Used to enter name for speed dial bin (see MMC 106)
ACTION
1. Press TRANSFER 105.
Display shows.
2. Dial station number (e.g. 205)
OR
Press UP or DOWN to select station and
press RIGHT soft key to move cursor.
If selected station has no speed dial bins, the
display will be as shown and a new
station may be selected.
Home Page
STATION SPEED DIAL
DISPLAY
[201] SPEED DIAL
00 :
[205] SPEED DIAL
00 :
[205] SPEED DIAL
SPDBLK NOT EXIST
Table of Contents
PROGRAMMING
PART 2 APRIL 2007