Samsung OfficeServ 7100 Technical Manual page 447

OfficeServ 7100
TECHNICAL MANUAL
MMC: 840
DESCRIPTION:
This MMC provides a means to register the IP keyphones with the OfficeServ 7100
system. During registration, the IP and MAC addresses are also registered. The
User ID and Password must match the table entry in this MMC for the IP keyphone
to be registered. System default numbers start at 3201~3280. System default User
ID's match the default station numbers. (3201~3280). The system default password
is 1234. IP keyphones must be individually programmed with User ID and Password
to register with the system.
NOTE: When changing any IP address/value, listed below, three digits must
be input for each (octet) field. Example 192.168.1.10 input must be: 192 168
001 010
USER ID: This is the ID the IP keyphone must match to register with the
•
OfficeServ 7100 system. This entry can be alphanumeric.
USER PSWD: This is the Password the IP keyphone must also have to register
•
with the OfficeServ 7100 system. This entry can be alphanumeric.
IP ADDR: This is the IP address of the IP once registered with the OfficeServ
•
7100 system. View only.
MAC ADDR: This is MAC address of the IP keyphone once registered with the
•
OfficeServ 7100 system. View only.
SIG PORT: Indicates the port number used for keyphone control signaling. This
•
information will be needed when traversing NAT routers, firewalls, etc. View only.
VOICE PORT: Indicates the port number used for transporting voice content.
•
This information will be needed when traversing NAT routers, firewalls, etc. View
only.
IP TYPE: This is the type of IP network used where the ITP is located: PRIVATE
•
or PUBLIC, or PUBLIC with FIREWALL. "PUBLIC with FIREWALL" option must
be selected when there are firewalls/NAT routers between system and remote
ITP's.
DSP TYPE: This selects which CODEC this keyphone's DSP will use. G.729A
•
(low bandwidth) or G.711 (high bandwidth). This applies to ITP to ITP
communication only. ITP to TDM follows MMC 835.
Table of Contents
Home Page
PROGRAMMING
PART 2 MAY 2009
IP SET INFO