NEC Univerge SV8100 Features And Specifications Manual page 914

Issue 5.0
Conditions
It is recommended that this feature use ISDN platform (as these trunks provide answer

supervision).
If an extension in a call forward chain has Call Forward with Both Ring, calls do not

continue routing to other extensions in the chain (Version 2500 or lower).
If the extension has Call Forward-Both Ring set to another extension, it will only continue to

forward if the Both ring location is forwarded (B/NA or NA) to VM and no where else
(Version 3000 or higher software is required).
ISDN and SIP trunks are only supported for the outbound call to the Mobile Extension

(Version 2500 or lower).
Analog, ISDN and SIP trunks are supported for the outbound call to the Mobile Extension

(Version 3000 or higher is required).
The analog line must provide calling line identification information to allow the Mobile

Extension to dial into the system to access features.
For the extension DTMF, the minimum Detect Level for the DTMF Tone (Program

80-03-03) must be set to allow a minimum detection level of -25dBm. This entry is
dependent on the Detect Level selected in Program 80-03-01.
The Mobile Extension uses the * to perform a flash, so any service codes which

begin with * must be changed (Programs 11-10, 11-11, 11-12, 11-13).
To provide a proper disconnect, Disconnect Supervision is required for the trunks

used for this feature.
When an entry is made in Program 15-22-01 for a Mobile Extension, ports are reserved for

Mobile Extension usage in groups of 2.
To keep consecutive port numbering for blades, you may wish to consider starting Mobile

Extensions at the upper extension port range.
The incoming Caller ID for a call that is forwarded to a mobile extension will not be

presented to the Mobile Extension (Version 2500 or lower).
When using Mobile Extension in a NetLink Network, the ISDN/PRI must be utilized in the

Primary System.
When adding or removing padding for trunks, use Program 14-01 for all trunks except the

PRI trunks in a Migration cabinet. Use Program 81-12 to add or remove padding for PRI
trunks in a migration cabinet.
Default Setting
No Mobile Extensions are configured.
2 - 888
UNIVERGE SV8100
Mobile Extension