NEC Univerge SV8100 Features And Specifications Manual page 789

UNIVERGE SV8100
Program
Program Name
Number
10-03-13 ETU Setup (PRTA PKG Setup) –
Loss of Signal Detection Limit
10-06-01 ISDN BRI Setup – TEI Selection
10-06-02 ISDN BRI Setup – DID Mode
10-06-03 ISDN BRI Setup – SPID 1
10-06-04 ISDN BRI Setup – SPID 2
14-01-36 Basic Trunk Data Setup –
Sending Caller Name on
Outgoing Calls (ISDN Trunk)
15-01-10 Basic Extension Data Setup –
Sending Caller Name on
Outgoing Calls (ISDN Trunk)
20-19-09 System Options for Caller ID –
Calling Party Name for ISDN
Trunk
21-12-01 ISDN Calling Party Number
Setup for Trunks – Calling Party
Number Data
ISDN Compatibility
Description/Comments
If the transmit/receive voltage is
less than the setting in Program
10-03-13, the system considers
this as Loss-Of-Signal and the PRI
does not come up. Note that there
are different values based on the
setting in Program 10-03-12 for
the PRI.
Select the method the system
uses when assigning Terminal
Endpoint Identifier (TEI) values to
the BRI Circuit.
Select the method the system
uses when assigning DID Mode to
the BRI Circuit.
Assign the SPID Number for
B-Channel 1.
Assign the SPID Number for
B-Channel 2.
Disable/Enable sending the Caller
Name on outgoing ISDN trunks.
Disable/Enable sending the Caller
Name on outgoing ISDN calls per
station.
Enter the Calling Party Name to be
used system wide for outgoing
ISDN calls.
If no data is entered, it will follow
the station name in Program
15-01-01.
Assign Calling Party Numbers for
each trunk (maximum 16 digits per
entry).
After the above programming

is complete a reset of the
CD-2BRIA is required.
Assigned Data
1
0 = Level 0
(lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3

4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7
(highest sensitivity)
(default = 2)
0 = Select by SPID
number
1 = Select by Channel
ID Number
(default = 0)
0 = Route by Called
Party Number
1 = Route by
Redirecting Number
(default = 0)
Dial up to 20 digits
(default not assigned)
Dial up to 20 digits
(default not assigned)
0 = Disable

1 = Enable
(default = 0)
0 = Disable

1 = Enable
(default = 0)
Up to 12 characters
(default = None)

(maximum 16 digits)
#
1-0, ,
Default:
(All trunks = No setting)
Issue 5.0
Level
2 3





2 - 763