NEC Univerge SV8100 Features And Specifications Manual page 458
Hide thumbs
Also See for Univerge SV8100:
- Features and specifications manual (2210 pages) ,
- Features & specifications manual (1174 pages) ,
- Programming manual (986 pages)
Table of Contents
Advertisement
Issue 5.0
Program
Program Name
Number
25-07-02
System Timers for VRS/DISA –
VRS/DISA No Answer Time
25-07-04
System Timers for VRS/DISA –
Calling Time to Automatic
Answering Telephone Set
25-07-05
System Timers for VRS/DISA –
Duration Time for Guidance
Message by Automatic
Answering Telephone Set
25-07-06
System Timers for VRS/DISA –
Duration Time for Guidance
Message by ACI
25-07-11
System Timers for VRS/DISA –
VRS/DISA Answer Delay Time
25-07-13
System Timers for VRS/DISA –
VRS/DISA Busy Tone Interval
25-07-14
System Timers for VRS/DISA –
Delayed VRS Answer Time
34-01-01
E&M Tie Line Basic Setup – DID/
E&M Start Signaling
34-01-02
E&M Tie Line Basic Setup –
Receive Dial Type for E&M Tie
Line
2 - 432
Description/Comments
A VRS/DISA caller can ring an
extension for this time before the
system sets the call as a Ring No
Answer. After this time expires,
the call follows the programmed
Ring No Answer routing (set in
Program 25-03 and Program
25-04).
Set the answering waiting time of
the automatic answering
extension when an incoming DID
trunk call is received.
Set the announcement time of the
automatic answering extension
before an incoming DID trunk
caller is disconnected.
Set the announcement time by the
ACI before an incoming DID trunk
caller is disconnected.
Set the time the system waits after
receiving an incoming VRS/DISA
call before the system
automatically answers the call.
If a DISA caller dials a busy
extension (and Program 25-04-01
is set to 0), the system plays busy
tone for this time before
disconnecting.
Assign the delay time from
switching from a normal incoming
status to DID mode. If this time is
set to 0, the call switches to DID
mode immediately.
Set the start signaling mode for
DID and tie trunks. DID and tie
trunks can use either immediate
start or wink start signaling.
For DID and tie trunks, set the
trunks signaling
type.
UNIVERGE SV8100
Assigned Data
1
0~64800 (seconds)
(default = 0)
0~64800 (seconds)
(default = 10)
0~64800 (seconds)
(default = 10)
0~64800 (seconds)
(default = 10)
0~64800 (seconds)
(default = 0)
0~64800 (seconds)
(default = 5)
0~64800 (seconds)
(default = 10)
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
(default = 1)
0 = DP
1 = DTMF
2 = MF
(default = 1)
Direct Inward Dialing (DID)
Level
2
3
Advertisement
Table of Contents
