NEC Univerge SV8100 Features And Specifications Manual page 930

Issue 5.0
Program
Program Name
Number
14-05-01 Trunk Group – Trunk Group
Number
14-06-01 Trunk Group Routing – Priority
Order Number
20-01-05 System Options – DTMF Receive
Active Time
20-06-01 Class of Service for Extensions
20-09-01 Class of Service Options
(Incoming Call Service) –
Second Call for DID/DISA/DIL/
E&M Override
2 - 904
Description/Comments
Program Tie Lines of similar type
into the same trunk group. The
system uses trunk groups for
outgoing access to Tie Lines (i.e.,
Service Code 704 + group). Also
see Program 34-05-01.
Set the priority order number 1~4.
After answering the Tie Line call,
the system attaches a DTMF
receiver to the Tie Line for this
time.
Assign a Class of Service (1~15)
to extensions.
Turn Off or On the extension ability
to receive a second call from a
DID, DISA, DIL, or tie line caller.
With this option set to 1, the

destination extension must
be busy for a second DNIS
caller to ring through. If the
destination extension does
not have a trunk or CAP key
available for the second call
and a previous call is ringing
the extension but has not yet
been answered, the second
caller hears busy regardless
of this program setting.
UNIVERGE SV8100
Assigned Data
1
Trunk Group Number:
0~100 Priority Number:
1~200

(default = Trunk Group
1, with priority in
ascending order.)
0 = Not Specify
1~100 : (Trunk Group
Number)
1001~1100 : (1000 +
Route Table Number)
Default:
Route 1, Order

Number 1 = 1 (Trunk
Group 1)
Order Numbers 2, 3, 4
= 0 (Not Specified)
All Other Routes
(2~100) and Order
Numbers (1~4) = 0
(Not Specified).
0~64800 (seconds)
(default = 10)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:

Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 1 for
COS 1~15)
Multiple Trunk Types
Level
2 3

