NEC Univerge SV8100 Features And Specifications Manual page 1020

Issue 5.0
Program
Program Name
Number
14-01-02 Basic Trunk Data Setup –
Transmit Level
14-01-08 Basic Trunk Data Setup – Toll
Restriction
14-02-01 Analog Trunk Data Setup –
Signaling Type (DP/DTMF)
14-02-02 Analog Trunk Data Setup – Ring
Detect Type
14-04-01 Behind PBX Setup
21-04-01 Toll Restriction Class for
Extensions
21-05-12 Toll Restriction Class – PBX Call
Restriction
21-06-08 Toll Restriction Table Data Setup
– PBX Access Code
2 - 994
Description/Comments
Set these options for compatibility
with the connected PBX.
For each PBX trunk port, Enable/
Disable Toll Restriction.
At default, Program 14-02-01 is
set to 2 (DTMF).
Set Extended Ring Detect or
Immediate Ring Detect for the
trunk. For T1 loop/ground start
trunks, this option must be set to 1
for the trunks to ring and light
correctly.
For each PBX trunk port, enter 1.
Make a separate entry for each
Night Service mode.
Assign a Toll Restriction Class
(1~15) to each extension.
For each Toll Restriction Class,
enter 1 to restrict calls on the PBX
trunk to outside calls only. Enter 0
to allow users to dial PBX
extensions.
Enter the system PBX access
codes. The system can have up
to four codes. A code can have
one or two digits. Valid entries are
#
0~9, and . Use Line Key 1 as
a don't care digit. If using Account
Codes, do not use the  in the
PBX Access Code.
UNIVERGE SV8100
Assigned Data
1
Trunks 1~200
1~63

(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
0 = Restriction
Disabled (No)

1 = Restriction Enabled
(Yes)
(default = 1)
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)

2=DTMF
(default = 2)
Trunks 1~200
0 = Normal/delayed
1 = Immediate Ringing

(default = 1)
0 = Stand Alone
(Trunk)
1 = Behind PBX (PBX)

2 = Not Used
3 = CTX assume 9
(default = 0)
Day/Night Mode
1~9 (9 = Power Failure
Mode)
1~15
(default = 2)
0 = Disable (No)
1 = Enable (Yes)
Default:
1~6, 8~15 = 0
7 = 1
Dial (Up to two digits)
default:
Table 1~4 = No Setting
PBX Compatibility
Level
2 3


