NEC Univerge SV8100 Features And Specifications Manual page 1043

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
14-02-09 Analog Trunk Data Setup – Busy
Tone Detection
14-02-14 Analog Trunk Data Setup – Loop
Start/Ground Start
Operation
None
Power Failure Transfer
Description/Comments
Set the basic options for each
analog trunk port.
Set the basic options for each
analog trunk port.
Assigned Data
1
0 = Disable

1 = Enable
(default = 0)
0 = Loop Start (Loop)
1 = Ground Start

(Ground)
(default = 0)
Issue 5.0
Level
2 3
2 - 1017