Trunk Group Routing - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

Trunk Group Routing sets outbound call routing options for users that dial the Trunk Group Routing code

(9) for trunk calls. Trunk Group Routing routes calls in the order specified by system programming. If a

user dials 9 and all trunks in the first group are busy, the system may route the call to another group.

When you are setting up your system, Trunk Group Routing helps you minimize the expense of toll calls.

For example, if your system has outbound WATS lines, OCC lines and DDD lines, use Trunk Group

Routing to route calls to the WATS lines first.

There are 100 available Trunk Groups and 100 Routes.

Outbound Call

DISA (Program 25-10) and Tie Lines (Program 34-03) have separate Trunk Group Routing

The system uses Trunk Group Routing programming (Program 14-06) when setting up

Ringing Line Preference.

Use trunk group programming to set the order in which users access trunks within a

specific trunk group.

Dialing 9 activates ARS, overriding trunk group routing if ARS service is turned on.

Call Forwarding, Off-Premise is not supported when using Alternate Trunk Group Routing.

Default Setting

Enabled (All trunks are in Group 1)

Trunk Group Routing

Least Expensive

First Choice

Trunk Group Routing

Second Choice

Most Expensive

Third Choice