NEC Univerge SV8100 Features And Specifications Manual page 1375

UNIVERGE SV8100
With an analog trunk, the Continue/Disconnect code may work using DTMF sounds from

the opposite side trunk. With an ISDN trunk, Program 14-01-25 must be enabled to detect
the Continue/Disconnect code.
The Continue/Disconnect code is not accepted while dialing a trunk.

Continue/Disconnect codes do not work if all receivers are busy.

When used with the Networking feature, both systems must be programmed the same for

the Continue/Disconnect codes.
A trunk can be set up to automatically tandem trunk/forward to an outside telephone

number or Speed Dial – System/Group Dialing bin.
Other programmed options for incoming and outgoing calls can affect how calls are

handled. Refer to Central Office Calls, Answering/Central Office Calls, Placing and check
or program these options as needed.
DISA calls also use the same Continue/Disconnect codes.

After initiating an unsupervised conference, selecting one of the CAP keys or line keys

allows you to barge-in to the conference.
If the station that barges into an unsupervised conference hangs up, the conference is

terminated.
A Trunk-to-Trunk transfer can be established by the following operation:

1. While talking to an outside party, press Hold.
2. Access a second outside line and dial the desired number.
3. Press Transfer to complete the Trunk-to-Trunk transfer.
When the second call is to be transferred to another station (Not Trunk-to-Trunk), the user should press

Hold at step 3, then dial the desired station, and press Transfer to complete the transfer.
Default Setting
Disabled
System Availability
Terminals
Multiline terminals and Single Line Telephones
Tandem Trunking (Unsupervised Conference)
Issue 5.0
2 - 1349