NEC Univerge SV8100 Features And Specifications Manual page 986

Issue 5.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
10-03-01 ETU Setup
10-09-01 DTMF and Dial Tone Circuit
Setup
15-03-01 Single Line Telephone Basic
Data Setup – SLT Signaling Type
2 - 960
Description/Comments
Set up and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
Allocate the circuits on the
CD-CP00-US ETUs for either
DTMF receiving or dial tone
detection. Program 14-01-13
Basic Trunk Data Setup – Loop
Supervision Enable (1) loop
supervision for each trunk that
should be able to use Call
Forwarding – Centrex.
For each UNIVERGE SV8100
voice mail extension, set this
option to 0.
UNIVERGE SV8100
Assigned Data
1
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
0 = DP
1 = DTMF
(default = 1)
(OPX) Off-Premise Extension
Level
2 3


