NEC Univerge SV8100 Features And Specifications Manual page 478

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

Issue 5.0
Program
Program Name
Number
25-06-02
VRS/DISA One-Digit Code
Attendant Setup – Destination
Number
25-07-01
System Timers for VRS/DISA –
VRS/DISA Dial Tone Time
25-07-02
System Timers for VRS/DISA –
VRS/DISA No Answer Time
25-07-03
System Timers for VRS/DISA –
Disconnect after VRS/DISA
retransfer to IRG
25-07-04
System Timers for VRS/DISA –
Calling Time to Automatic
Answering Telephone Set
25-07-05
System Timers for VRS/DISA –
Duration Time for Guidance
Message by Automatic
Answering Telephone Set
25-07-06
System Timers for VRS/DISA –
Duration Time for Guidance
Message by ACI
2 - 452
Description/Comments
Set up single digit dialing for
Automated Attendant callers. For
each VRS Message programmed
to answer outside calls, specify:
The digit the Automated
Attendant caller dials (1~12,
where 10 = 0, 11 = and 12 =
#
). (Keep in mind that if you
assign destinations to digits
three and four, outside callers
cannot dial system extensions
that begin with that digit.)
The destination reached (four
digits maximum) when the
caller dials the single digit
code.
After answering the DISA trunk,
the system waits this time for the
caller to dial the first digit of the
DISA password. If the caller fails
to dial during this time, the system
drops the call.
A DISA caller can ring an
extension for this time before the
system sets the call as a Ring No
Answer. After this time expires,
the call follows the programmed
Ring No Answer routing (set in
Program 25-03 and 25-04).
From DISA trunk, when the call
may go to Incoming Ring Group
(IRG) of Program 25-03/25-04.
This setting determines the time
the call is ringing in the IRG.
Set the answering waiting time of
the automatic answering
extension when an incoming DID
trunk call is received.
Set the announcement time of the
automatic answering extension
before an incoming DID trunk
caller is disconnected.
Set the announcement time by the
ACI after which an incoming DID
trunk caller is disconnected.
UNIVERGE SV8100
Assigned Data
Up to eight digits
(default not assigned)
0~64800 (seconds)
(default = 10)
0~64800 (seconds)
(default = 0)
0~64800 (seconds)
(default = 60)
0~64800 (seconds)
(default = 10)
0~64800 (seconds)
(default = 10)
0~64800 (seconds)
(default = 10)
Direct Inward System Access (DISA)
Level
1
2
3

Advertisement

Table of Contents
loading

Table of Contents