Rear Sprocket Removal And Installation - Suzuki RMX450Z Service Manual

3A-4 Drive Chain / Drive Train / Drive Shaft:
5) Remove the snap ring (5) and remove the engine
sprocket (6).
5
Installation
Install the engine sprocket in the reverse order of
removal. Pay attention to the following points:
• Install the engine sprocket (1) and snap ring (2).
CAUTION
!
Replace the snap ring with a new one. Seat
the snap ring in the groove and locate its end
as shown in the illustration.
Special tool
: 09900–06107 (Snap ring remover (Open
type))
1
2
"A": Thrust
• When install the front chain guide (3), bring the "UP"
letters and arrow mark "C" upward.
"C"
6
IA02J1310003-03
"A"
1
2
"B"
IA02J1310020-01
"B": Sharp edge
"C"
3
IA02J1310022-02
• Install the engine sprocket cover (4).
• Apply thread lock to the engine sprocket cover bolts
(5) and tighten them to the specified torque.
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT "1342" or equivalent)
Tightening torque
Engine sprocket cover bolt (a): 11 N·m (1.1 kgf-
m, 8.0 lbf-ft)
5
(a)
4
5
(a)
• Adjust the drive chain slack. Refer to "Drive Chain
Inspection and Adjustment" in Section 0B (Page 0B-
20).

Rear Sprocket Removal and Installation

Removal
1) Remove the rear wheel assembly by disengaging
the drive chain. Refer to "Rear Wheel Assembly
Removal and Installation" in Section 2D (Page 2D-
11).
2) Remove the rear sprocket bolts and nuts and
separate the rear sprocket (1).
1
IA02J1310005-04
BA02J23106004
IA02J1310006-01