Clear Memory Mode - Subaru 2009 IMPREZA Service Manual

13.Clear Memory Mode

A: OPERATION
NOTE:
When Clear Memory Mode is performed in OBD
mode of Subaru Select Monitor, only DTCs are
cleared.
1. SUBARU SELECT MONITOR
(NORMAL MODE)
1) On «Main Menu» display, select {Each System
Check}.
2) On «System Selection Menu» display, select
{Engine Control System}.
3) Click the [OK] button after the information of en-
gine type has been displayed.
4) On «Engine Diagnosis» display, select {Clearing
Memory}.
5) When the "Clear Memory?" is shown on the
screen, click the [YES] button.
6) When "Done" and "Turn off the ignition switch."
are shown on the display screen, turn the ignition
switch to OFF.
NOTE:
• Initial diagnosis of electronic throttle control is
performed after memory clearance. Wait for 10
seconds or more after turning the ignition switch to
ON, and then start the engine.
• For detailed operation procedures, refer to "PC
application help for Subaru Select Monitor".
2. SUBARU SELECT MONITOR
(OBD MODE)
1) On «Main Menu» display, select {Each System
Check}.
2) On «System Selection Menu» display, select
{Engine Control System}.
3) Click the [OK] button after the information of en-
gine type has been displayed.
4) On «Engine Diagnosis» display, select {OBD
System}.
5) On «OBD Menu» display, select {Clear Diagnos-
tic Code}.
6) When the "Clear Diagnostic Code?" is shown on
the screen, click the [Yes] button.
7) When "Done" and "Turn off the ignition switch."
are shown on the display screen, turn the ignition
switch to OFF.
NOTE:
• Initial diagnosis of electronic throttle control is
performed after memory clearance. Wait for 10
seconds or more after turning the ignition switch to
ON, and then start the engine.
• For detailed operation procedures, refer to "PC
application help for Subaru Select Monitor".
Clear Memory Mode
3. GENERAL SCAN TOOL
For clear memory procedures using the general
scan tool, refer to "General Scan Tool Instruction
Manual".
NOTE:
Initial diagnosis of electronic throttle control is per-
formed after memory clearance. For this reason,
start the engine after 10 seconds or more have
elapsed since the ignition switch was turned to ON.
EN(H4SO)(diag)-55
ENGINE (DIAGNOSTICS)