Subaru 2009 IMPREZA Service Manual page 252

MECHANICAL
5) Remove the lifting device and wire ropes.
6) Remove the garage jack.
7) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
T2
8) Remove the ST from torque converter clutch
case. (AT model)
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing the ST.
ST 498277200 STOPPER SET
9) Install the starter. <Ref. to SC(H4SO)-7, IN-
STALLATION, Starter.>
Engine Assembly
LU-00222
T1
MT-00085
ST
ME-00217
ME(H4SO)-34
10) Install the torque converter clutch to drive plate.
(AT model)
(1) Insert the wrench into the crank pulley bolt
and rotate the crank pulley to install the bolts
which hold torque converter clutch to drive plate.
NOTE:
Be careful not to drop bolts into the torque convert-
er clutch case.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
(2) Install the service hole plug.
11) Install the power steering pump.
(1) Install the power steering pump.
Tightening torque:
Refer to "COMPONENT" of "Power Steering"
for the tightening torque. <Ref. to PS-3, COM-
PONENT, General Description.>
(2) Connect the power steering pump switch
connector.
(3) Install and adjust the front side belt. <Ref. to
ME(H4SO)-39, FRONT SIDE BELT, INSTAL-
LATION, V-belt.>
ME-00212
ME-00037
ME-03004