Subaru 2009 IMPREZA Service Manual page 405

(3) Pass stopper (B) through the shaft assem-
bly, and attach snap ring (A).
(A)
(B)
NOTE:
Use new stoppers and snap rings.
(4) Using a press, pressure fit stopper (B) into
snap ring (A).
(A)
(B)
4) Assemble the overrunning clutch, internal gear
assembly, shaft and shift lever as a single unit into
the starter housing assembly.
NOTE:
Apply grease to the moving parts of the shift lever.
Grease:
Multemp #6129 or equivalent
Starter
5) Apply grease to the inside of the internal gear
assembly and pinion gear, and attach the pinion
gear to the internal gear assembly.
NOTE:
• Apply grease evenly to the contact surfaces of
each gear.
• Be careful that no debris becomes attached.
Grease:
Molykote
SC-02134
6) Attach rubber seal (A), plate (B), and rubber seal
(C).
SC-00068
7) Assemble the armature assembly to the yoke
assembly.
SC-02235
SC(H4SO)-11
STARTING/CHARGING SYSTEMS
®
AG650 or equivalent
(A)
SC-02229
(B)
(C)
SC-02230
SC-02228