Subaru 2009 IMPREZA Service Manual page 259

6) Place the belt guide while aligning it with the belt
line of the crank pulley on the front side belt side.
7) Insert the belt guide holder into the service hole
of the crank pulley so that the belt guide comes in
between.
NOTE:
Place the belt guide holder with the longer side up.
8) Slowly turn the crank pulley clockwise until the
belt guide comes to approximately 45°.
V-belt
ME-03503
ME-03504
45
ME-03505
ME(H4SO)-41
9) Place the rib surface of the rear side belt into the
crank pulley groove, so that the rear side belt
comes in between the belt guide holder.
CAUTION:
When it is difficult to place the rear side belt to
the crank pulley groove, pull out the belt guide
holder half way, then place the rear side belt
into the groove so that it comes in between the
belt guide holder.
10) Place the tool through the loop of the rear side
belt, and set on the crank pulley bolt.
N N N N N N N N N N N N N N N N N N NG NG NG N N
O O O O O O O O O O O O O O O O O OK K O O O K K K K K K K K K K K K K K K K K K K K K K K K K K K K K K K K K O K O O O O O K K K K OK K K OK O O O O O O O O O O O O OK O O O O OK O OK O O OK
MECHANICAL
ME-03506
G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G
K K K K K K K
ME-03507