Subaru 2009 IMPREZA Service Manual page 283

(8) Further tighten the bolts (a) and (b) by 40 —
45°.
CAUTION:
Make sure the total "re-tightening angle" of the
step (7) and (8) does not exceed 90°.
( a )
( c )
3) Install the oil level gauge guide. (LH side)
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
4) Install the camshaft. <Ref. to ME(H4SO)-61, IN-
STALLATION, Camshaft.>
5) Install the valve rocker assembly. <Ref. to
ME(H4SO)-58, INSTALLATION, Valve Rocker As-
sembly.>
6) Install the A/C compressor bracket on cylinder
head.
Tightening torque:
36 N·m (3.7 kgf-m, 26.6 ft-lb)
7) Install the cam sprocket. <Ref. to ME(H4SO)-54,
INSTALLATION, Cam Sprocket.>
8) Install the timing belt. <Ref. to ME(H4SO)-50,
INSTALLATION, Timing Belt.>
9) Adjust the valve clearance. <Ref. to ME(H4SO)-
29, ADJUSTMENT, Valve Clearance.>
10) Install the rocker cover.
(1) Install the rocker cover gasket to the rocker
cover.
NOTE:
Use a new rocker cover gasket.
Cylinder Head
( f )
( d )
( b )
( e )
ME-02746
ME(H4SO)-65
(2) Temporarily tighten the bolts in alphabetical
order shown in the figure, tighten them in two
stages.
Tightening torque:
First
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
Second (only (a) and (b) are tightened)
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
RH side
(f)
(d)
(b)
LH side
(f)
(d)
(b)
11) Install the timing
ME(H4SO)-48, INSTALLATION, Timing Belt Cov-
er.>
12) Install the crank pulley. <Ref. to ME(H4SO)-46,
INSTALLATION, Crank Pulley.>
13) Install the intake manifold. <Ref. to FU(H4SO)-
18, INSTALLATION, Intake Manifold.>
14) Install the V-belts. <Ref. to ME(H4SO)-39, IN-
STALLATION, V-belt.>
MECHANICAL
(a)
(c)
(e)
ME-02715
(a)
(c)
(e)
ME-02716
belt cover. <Ref. to