Subaru 2009 IMPREZA Service Manual page 464

8) Connect SDI to data link connector located in the
lower portion of the instrument panel (on the driv-
er's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and general scan tool.
9) Start the PC.
10) Turn the ignition switch to ON (engine OFF)
and run the "PC application for Subaru Select Mon-
itor".
11) On «Main Menu» display, select {Each System
Check}.
12) On «System Selection Menu» display, select
{Engine Control System}.
13) Click the [OK] button after the information of
engine type has been displayed.
14) On «Engine Diagnosis» display, select {Dealer
Check Mode Procedure}.
15) When the «Perform Inspection (Dealer Check)
Mode?» is shown on the screen, click the [Next]
button.
16) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding DTC appears on the display screen.
NOTE:
• For detailed operation procedures, refer to
"PC application help for Subaru Select Monitor".
• For details concerning DTC, refer to "List of Di-
agnostic Trouble Code (DTC)".
<Ref. to EN(H4SO)(diag)-86, List of Diagnostic
Trouble Code (DTC).>
• Release the parking brake.
• The speed difference between front and rear
wheels may light the ABS warning light, but this
does not indicate a malfunction. When engine
control diagnosis is finished, perform the ABS
memory clearance procedure of self-diagnosis
function. <Ref. to ABS(diag)-21, Clear Memory
Mode.>
Inspection Mode
3. GENERAL SCAN TOOL
1) After performing the diagnostics and clearing the
memory, check that no DTC remains. <Ref. to
EN(H4SO)(diag)-55, Clear Memory Mode.>
2) Warm up the engine.
3) Connect the delivery (test) mode connector (A)
located under the glove box.
EN-06148
4) Connect the general scan tool to data link con-
nector located in the lower portion of the instrument
panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and general scan tool.
5) Start the engine.
NOTE:
• Ensure the selector lever is placed in "P" range
before starting. (AT model)
• Depress the clutch pedal when starting engine.
(MT model)
6) Turn the neutral position switch to ON using se-
lect lever or shift lever.
7) Depress the brake pedal to turn the brake switch
ON. (AT model)
8) Keep the engine speed in 2,500 — 3,000 rpm
range for 40 seconds.
EN(H4SO)(diag)-47
ENGINE (DIAGNOSTICS)
(A)
EN-06146
EN-06148