Subaru 2009 IMPREZA Service Manual page 48

PRE-DELIVERY INSPECTION
Checks after Dynamic Test
Operation
48. ATF level
49. Power steering fluid level
50. Fluid leakage
51. Water leak test
52. Appearance 2
1. APPEARANCE
• If the vehicle is covered with protective coating,
visually check the vehicle body for damage and
dents.
• If there is no protective coat, check the painted
surface of the vehicle body for damage or rust, and
repair as necessary.
• Check the window glass, door glass, and lights
for any cracks or damage, and replace as neces-
sary.
• Visually check the plated parts, such as the
grilles and door knobs, for damage or loss of gloss
and replace the parts as necessary.
• Check the instrument panel, console and trim for
stains or dirt.
2. TIRE
• Check for damage on the outside surface of the
tires.
• Refer to the following table and inspect the tire
air pressure.
Tire size
P205/55R16 230 (2.3, 33)
P205/50R17 230 (2.3, 33)
225/45R17 230 (2.3, 33)
3. FUSE INSTALLATION
Fuses for the room light circuit on initially delivered
vehicles are removed to prevent battery discharge.
Attach the 20 A fuse (A) as shown in the figure.
(A)
Pre-delivery Inspection
Check that the ATF level is correct.
Check that the power steering fluid level is normal.
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
1. Remove the protective coating (if equipped).
2. Check the body paints for damage and stain.
3. Check the plated parts for damage and rust.
Tire inflation pressure
2
kPa (kgf/cm , psi)
Front Rear
220 (2.2, 32)
220 (2.2, 32)
220 (2.2, 32)
PI-00399
Check point
4. DOOR LOCK/UNLOCK AND OPEN/
CLOSE OPERATIONS
1) Using the key, lock and unlock the door several
times to check for normal operation. Open and
close the door several times for smooth movement.
(B)
(A)
(A) Unlock
(B) Lock
2) Close the door of driver seat completely, and
place the door lock knob (A) to the lock position.
Then pull the inner remote (B) to ensure that doors
will not open.
For other doors, place the door lock knob (A) to lock
position and then pull the inner remote (B) to en-
sure that doors will not open.
(B)
(A) Door lock knob
(B) Inner remote
PI-4
PI-00425
(A)
PI-00401