Subaru 2009 IMPREZA Service Manual page 57

7) The alarm system is in the non-monitoring con-
ditions if the driver's side door is unlocked, the
buzzer sounds twice, the hazard light flashes twice,
the room light turns on, and the security display
light turns off.
NOTE:
On models without the immobilizer feature, the se-
curity display light does not flash after the "UN-
LOCK/DISARM" of the keyless transmitter is
pressed.
• Alarm system non-monitoring condition (models
with immobilizer)
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 3 seconds
8) Press the "LOCK/ARM" button once on the key-
less transmitter with one of the doors (including the
rear gate) opened.
9) Check that the buzzer sounds 5 times to give the
door not fully closed warning.
10) Close all the doors including rear gate.
Pre-delivery Inspection
PI-00504
(C)
PI-00266
PI-00357
11) Check that the system is in the monitoring con-
dition (all the doors become locked and the buzzer
sounds once, and the hazard light flashes once).
• Alarm system monitoring prepared condition
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 2 seconds
12) Check that the system enters monitoring condi-
tion 30 seconds after the condition in 11).
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 2 seconds
13) Press the "UNLOCK/DISARM" button on the
keyless transmitter once and turn into non-monitor-
ing condition.
PI-13
PRE-DELIVERY INSPECTION
(C)
PI-00315
(C)
PI-00265
PI-00358