Subaru 2009 IMPREZA Service Manual page 58

PRE-DELIVERY INSPECTION
14) With one of all the doors open (including the
rear gate), press the "LOCK" side of the power door
lock switch.
• Driver's side
• Passenger's side
15) Close all the doors including rear gate.
16) If all doors become locked, the buzzer sounds
once, and the hazard light flashes once, the alarm
system is in the monitoring prepared condition.
• Alarm system monitoring prepared condition
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 2 seconds
Pre-delivery Inspection
PI-00447
PI-00428
(C)
PI-00315
17) Check that the system enters monitoring condi-
tion 30 seconds after the condition in 16).
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 2 seconds
18) When the alarm system is in the monitoring
condition, use the inner lock knob or the key to un-
lock the door, and open the door.
19) Check that the alarm condition occurs (horn
sounds continuously, hazard light flashes, security
indicator illuminates).
20) Check that the condition in 19) continues for 30
seconds or more, or until the "UNLOCK/DISARM"
button of the keyless transmitter is pressed.
21) Check that in the monitoring condition, even if
the ignition key is turned to the "START" position,
the starter motor does not turn, and that the engine
does not start.
NOTE:
When the ignition is turned to ON by using the key
that has a genuine transponder in it, the alarm will
cease and the engine will start.
22) On models equipped with an impact sensor, hit
the windshield glass with your hand with the alarm
system in the monitoring condition, to check that
the alarm condition occurs.
23) When none of above is applicable, perform
troubleshooting for the security system. <Ref. to
SL-26, INSPECTION, Security System.>
PI-14
(C)
PI-00265