Subaru 2009 IMPREZA Service Manual page 300

MECHANICAL
(7) Set the parts so that the #3 and #4 cylinders
are on the upper side. Following the same pro-
cedures as used for #1 and #2 cylinders, install
the pistons and piston pins.
(8) Install the service hole cover.
NOTE:
Use new O-rings.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
22) Install the water pipe assembly.
NOTE:
Use new O-rings.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
23) Install the baffle plate.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
24) Install the oil strainer.
NOTE:
Use new O-rings.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
25) Tighten the oil strainer stay together with the
baffle plate.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
Cylinder Block
26) Apply liquid gasket to the mating surfaces of oil
pan, and install the oil pan.
NOTE:
Install within 5 min. after applying liquid gasket.
Liquid gasket:
THREE BOND 1217G (Part No. K0877Y0100)
or equivalent
Tightening torque:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
27) Apply liquid gasket to the mating surfaces of
the oil separator cover and the threaded portion of
bolt (A) shown in the figure (when reusing the bolt),
ME-00300
and then install the oil separator cover.
NOTE:
• Install within 5 min. after applying liquid gasket.
• Use new oil separator cover.
Liquid gasket:
• Mating surface
THREE BOND 1217G (Part No.
K0877Y0100) or equivalent
• (A) bolt thread (when reusing bolts)
THREE BOND 1324 (Part No. 004403042) or
equivalent
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
ME(H4SO)-82
(A) Gasket
(A)
LU-02353
(A)
ME-03333