Subaru 2009 IMPREZA Service Manual page 61

Step
1 CHECK TPMS WARNING LIGHT.
1) IG ON
2) Check the TPMS warning light condition.
2 TURN THE BULB POWER SUPPLY TO ON.
1) Touch the transmitter registration tool to the
side wall area near the air valve on the tire.
2) Press the switch and hold it for 4 seconds or
more.
3) Perform the same procedures for the four
tires.
3 CHECK ID.
1) While checking the display of the Subaru
Select Monitor, transmit the transmitter ID using
the transmitter registration tool.
4 RE-REGISTER ID.
1) Register the transmitter.
2) After the completion of ID registration,
check if the TPMS warning light condition
becomes *3.
5 CHECK TIRE INFLATION PRESSURE.
1) Check the tire inflation pressures of all the
four wheels.
2) Adjust the tire inflation pressures.
3) Check the TPMS warning light condition.
6 DIAGNOSIS.
1) Check the trouble history using the Subaru
Select Monitor.
7 CLEAR TROUBLE HISTORY.
1) Using the Subaru Select Monitor, perform
the clear memory.
8 CHECK TPMS WARNING LIGHT.
1) IG OFF
2) IG ON
3) Check the TPMS warning light condition.
9 CHECK TPMS WARNING LIGHT.
10 TRANSMIT DATA FORCIBLY.
1) Touch the transmitter registration tool to the
side wall area near the air valve on the tire.
2) Press the switch and hold it for 4 seconds or
more.
3) Perform the same procedures for the four
tires.
11 TRANSMIT DATA FORCIBLY.
1) Touch the transmitter registration tool to the
side wall area near the air valve on the tire.
2) Press the switch and hold it for 4 seconds or
more.
3) Perform the same procedures for the four
tires.
Pre-delivery Inspection
Check
Does the TPMS warning light
condition become *1?
Does the TPMS warning light
condition become *3?
Does the ID of equipped trans-
mitter match with the registered
ID?
Does the TPMS warning light
condition become *3?
Does the TPMS warning light
condition become *3?
Is DTC displayed on the Subaru
Select Monitor?
Is DTC displayed on the Subaru
Select Monitor?
Does the TPMS warning light
display show *3?
Does the TPMS warning light
condition become *1 or *2?
Does the TPMS warning light
condition become *3?
Does the TPMS warning light
condition become *3?
PI-17
PRE-DELIVERY INSPECTION
Yes No
Go to step 2. Go to step 3.
Go to step 10. Go to step 9.
Go to step 6. Go to step 4.
Go to step 11. Go to step 6.
Go to step 7. Go to step 6.
Go to step 7.
Repair the trouble
cause. <Ref. to
TPM(diag)-2,
PROCEDURE,
Basic Diagnostic
Procedure.>
Go to step 8.
Repair the trouble
cause. <Ref. to
TPM(diag)-2,
PROCEDURE,
Basic Diagnostic
Procedure.>
Finish the check Perform the diag-
operation. nosis again. <Ref.
to TPM(diag)-2,
PROCEDURE,
Basic Diagnostic
Procedure.>
Go to step 3. Go to step 5.
Finish the check Go to step 5.
operation.
Go to step 7. Go to step 5.