Clear Memory Mode - Subaru Legacy 2002 Service Manual

13. Clear Memory Mode

A: OPERATION
1. SUBARU SELECT MONITOR (NORMAL
MODE)
S078513A1601
1) On the Main Menu
the {2. Each System Check} and press the [YES]
key.
2) On the System Selection Menu
screen, select the {Engine Control System} and
press the [YES] key.
3) Press the [YES] key after displayed the infor-
mation of engine type.
4) On the Engine Diagnosis
select the {Clear Memory} and press the [YES]
key.
5) When the 'Done' and 'Turn Ignition Switch OFF'
are shown on the display screen, turn the Subaru
Select Monitor and ignition switch to OFF.
NOTE:
¼ After the memory has been cleared, the idle air
control solenoid valve must be initialized. To do
this, turn the ignition switch to the ON position.
Wait 3 seconds before starting the engine.
¼ For detailed operation procedure, refer to the
SUBARU SELECT
MANUAL.
2. SUBARU SELECT MONITOR (OBD
MODE)
S078513A1602
1) On the Main Menu
the {2. Each System Check} and press the [YES]
key.
2) On the System Selection Menu
screen, select the {Engine Control System} and
press the [YES] key.
3) Press the [YES] key after displayed the infor-
mation of engine type.
4) On the Engine Diagnosis
select the {OBD System} and press the [YES] key.
5) On the OBD Menu
the {4. Diagnosis Code(s) Cleared} and press the
[YES] key.
6) When the 'Clear Diagnostic Code?' is shown on
the display screen, press the [YES] key.
7) Turn Subaru Select Monitor and ignition switch
to OFF.
NOTE:
¼ After the memory has been cleared, the idle air
control solenoid valve must be initialized. To do
this, turn the ignition switch to the ON position.
Wait 3 seconds before starting the engine.
¼ For detailed operation procedure, refer to the
SUBARU SELECT
MANUAL.
CLEAR MEMORY MODE
S078513
S078513A16
display screen, select
display
display screen,
MONITOR OPERATION
display screen, select
display
display screen,
display screen, select
MONITOR OPERATION
3. OBD-II GENERAL SCAN TOOL
For clear memory procedures using the OBD-II
general scan tool, refer to the OBD-II General
Scan Tool Instruction Manual.
After the memory has been cleared, the idle air
control solenoid valve must be initialized. To do
this, turn the ignition switch to the ON position.
Wait 3 seconds before starting the engine.
EN-45
Engine (Diagnostics)
S078513A1603