Subaru 2009 IMPREZA Service Manual page 403

8) Remove rubber seal (A), plate (B), and rubber
seal (C).
(A)
9) Lightly tap the starter housing assembly with a
plastic hammer as shown in the figure, and remove
the overrunning clutch, internal gear assembly,
shaft and shift lever together as one unit.
Starter
10) Use the following procedures to remove the
overrunning clutch from the shaft.
(1) Use an appropriate tool (such as a fit socket
wrench), and remove the stopper from snap
(B)
ring by lightly tapping the stopper with a plastic
hammer.
(C)
SC-02230
(2) Remove snap ring (A) from the shaft, and
remove stopper (B).
SC-02231
SC-02235
SC(H4SO)-9
STARTING/CHARGING SYSTEMS
(D)
(A) Appropriate tool
(B) Snap ring
(C) Shaft
(D) Stopper
(A)
(B)
(A)
(B)
(C)
SC-02232
SC-02134