Subaru 2009 IMPREZA Service Manual page 937

Hide thumbs Also See for 2009 IMPREZA:

FUEL INJECTION (FUEL SYSTEMS)

• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing

• Remove contamination including dirt and corrosion before removal, installation or disassembly.

• Keep the disassembled parts in order and protect them from dust and dirt.

• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, in-

stallation, disassembly and replacement.

• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Place shop jacks or rigid racks at the specified points.

• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from the bat-

• Place "NO OPEN FLAMES" signs near the working area.

• Prepare a container and cloth to prevent scattering of fuels when performing work where fuels can be

spilled. If the fuel spills, wipe it off immediately to prevent from penetrating into floor or flowing out for envi-

ronmental protection.

• Follow all government and local regulations concerning disposal of refuse when disposing fuel.

D: PREPARATION TOOL

1. SPECIAL TOOL

ILLUSTRATION

ST18353AA000

ST18371AA000

ST18471AA000

General Description

CLAMP PLIERS

FU(H4DOTC)-12

• Used for removing and installing the PCV

• This tool is made by the French company

CAILLAU. (code) 54.0.000.205

To make it easier to obtain, it has been provided

with a tool number.

Used for disconnecting the quick connector on

the fuel return hose of the engine compartment.

Used for draining fuel.