Subaru 2009 IMPREZA Service Manual page 168

B: INSTALLATION
1) Support the fuel tank with a transmission jack,
set the fuel tank in place, and temporarily tighten
the bolts of the fuel tank band.
WARNING:
A helper is required to perform this work.
2) Securely insert the fuel filler hose (A) and evap-
oration hose (B) into the specified position, then at-
tach the clamp or clip as shown in the figure.
Tightening torque:
2.5 N·m (0.3 kgf-m, 1.8 ft-lb)
(A)
( 1 )
(1) Hose
(2) Clamp or clip
(3) Pipe
FU-03282
(B)
FU-03422
( 2 )
( 3 )
L/2
L
FU-00104
FU(H4SO)-57
Fuel Tank
3) Connect the quick connector of the evaporation
hose to the evaporation pipe.
CAUTION:
• Check that there is no damage or dust on the
quick connector. If necessary, clean the seal
surface of the pipe.
• When connecting the quick connector, se-
curely insert the pipe all the way before locking
the retainer.
• When it is difficult to lock the retainer, make
sure that the pipe is securely inserted.
• Make sure that the quick connector is secure-
ly connected.
(a) Retainer
FUEL INJECTION (FUEL SYSTEMS)
(a)
(a)
EC-02295
FU-03424
(a)