Subaru 2009 IMPREZA Service Manual page 46

PRE-DELIVERY INSPECTION
1. Pre-delivery Inspection
A: GENERAL DESCRIPTION
The purposes of the pre-delivery inspection (PDI) are as follows.
• Remove the additional parts used for ensuring the vehicle quality during transportation and restore the ve-
hicle to its normal condition.
• Check the vehicle before delivery is in normal condition.
• Check the vehicle or parts for any damage occurred during transportation or storage.
• Check the vehicle after repair is in normal condition.
• Make sure to provide a complete vehicle to customer.
For above reasons, all SOAs (dealerships) must carry out the PDIs before delivery of vehicle.
Refer to this manual unless otherwise specified.
B: PRE-DELIVERY INSPECTION (PDI) PROCEDURE
Perform the procedures indicated in the table below.
Static Checks Just After Vehicle Receipt
Operation
1. Appearance
2. Tire
3. Fuse installation
4. Door lock/unlock and open/close operations
5. Child safety lock
6. Trunk lid open/close operations
7. Rear gate lock/unlock and open/close operation 1. Check if the rear gate can be unlocked normally through the emergency hole.
8. Operation check of trunk lid release lever
9. Fuel lid opener lock release lever
10. Accessory
11. Front hood lock release
12. Battery
13. Brake fluid
Pre-delivery Inspection
1. If the vehicle is covered with protective coating, visually check the vehicle
body for damage and dents. If the protective coating has been removed,
visually check the painted body surfaces in detail for damage or rust.
2. Visually check the glass and light lenses for any damage, cracks or exces-
sive gaps between body sheet metal.
3. Visually check the plated parts for any damage.
4. Check the instrument panel, console and trim for stains or dirt.
1. Check the tires for damage, defective, and dents on wheels.
2. Check the tire air pressure.
If the vehicle is about to be delivered to customer, attach the room lamp fuse.
1. Using the key, check the door can be locked or unlocked normally.
2. Open and close all doors to check that there are no problems.
3. Operate the power door lock switch to check that the rear gate locks and
unlocks normally.
Check the child safety lock system operates normally.
1. Using the key, check that the trunk lid can be locked or unlocked normally.
2. Operate the trunk lock release lever to check that the trunk lid opens normally.
3. Use the valet key to check that the lock cannot be released.
4. Open and close the trunk lid to check that there are no problems.
2. Open and close the rear gate to check that there are no problems.
Operate the trunk lid release lever to check that the trunk lock is unlocked
normally.
Operate the fuel lid opener to check that the fuel filler lid can be unlocked
normally.
Check that the following accessories are equipped.
• Owner's manual
• Warranty booklet
• Maintenance note
• Spare key
• Key No. plate
• Jack
• Tool set
• Spare tire
• Towing hook
Operate the front hood lock release lever to check that the front hood opens
normally.
Check the battery for any abnormal conditions such as rust or traces of bat-
tery fluid leaks.
Check the brake fluid amount.
PI-2
Check point