Subaru 2009 IMPREZA Service Manual page 377

LUBRICATION
18) Remove the oil strainer.
19) Remove the baffle plate.
(D)
(C)
(B)
(A)
(A) Oil pan
(B) Oil strainer
(C) Baffle plate
(D) Cylinder block
B: INSTALLATION
NOTE:
Before installing the oil pan, clean the mating sur-
face of oil pan and engine block.
1) Make sure that the seals (A) are installed se-
curely on the baffle plate in a direction as shown in
the figure below.
NOTE:
Use a new seal.
(A)
Oil Pan and Strainer
2) Install the baffle plate.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
3) Install the oil strainer to cylinder block.
NOTE:
Use new O-rings.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
4) Tighten the oil strainer stay together with the baf-
fle plate.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
5) Apply liquid gasket to the mating surfaces of oil
pan, and install the oil pan.
NOTE:
• Use a new gasket.
• Install within 5 min. after applying liquid gasket.
Liquid gasket:
THREE BOND 1217G (Part No. K0877Y0100)
or equivalent
LU-02334
LU-00052
LU(H4SO)-16
(A) Gasket
(A)
LU-02353