Subaru 2009 IMPREZA Service Manual page 206

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
11.Pressure Control Solenoid
Valve
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Disconnect connector (A) from the pressure con-
trol solenoid valve.
5) Disconnect the evaporation hose (B) from the
pressure control solenoid valve.
6) Remove the nuts (C) which secure the bracket to
the fuel tank.
(C)
7) Remove the pressure control solenoid valve and
bracket as a unit.
8) Remove the pressure control solenoid valve
from the bracket.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.35 N·m (0.7 kgf-m, 5.4 ft-lb)
Pressure Control Solenoid Valve
IN-00203
(B)
(A)
(B)
EC-02298
EC-02311
EC(H4SO)-16
C: INSPECTION
1. PRESSURE CONTROL SOLENOID VALVE
Measure the resistance between the pressure con-
trol solenoid valve terminals.
2 1
Terminal No.
1 and 2
2. OTHER INSPECTIONS
Make sure the hoses are not cracked or loose.
EC-02454
Standard
20 — 30