Subaru 2009 IMPREZA Service Manual page 354

COOLING
10) Lower the vehicle.
11) Disconnect the over flow hose.
12) Remove the reservoir
CO(H4SO)-27, REMOVAL, Reservoir Tank.>
13) Remove the air intake duct. <Ref. to IN(H4SO)-
8, REMOVAL, Air Intake Duct.>
14) Disconnect the radiator inlet hose from engine.
15) Remove the radiator upper brackets.
16) Lift the radiator up and remove the radiator
from vehicle.
B: INSTALLATION
1) Attach the radiator lower cushion to the hole on
the radiator lower bracket.
2) Install the radiator to vehicle.
NOTE:
Make pins on the lower side of radiator be fitted into
the radiator lower cushions.
Radiator
tank. <Ref. to
CO-02400
LU-02365
CO-00041
CO(H4SO)-20
3) Install the radiator upper brackets and tighten
the bolts.
Tightening torque:
12 N·m (1.2 kgf-m, 8.9 ft-lb)
4) Connect the radiator inlet hose.
5) Install the air intake duct. <Ref. to IN(H4SO)-8,
INSTALLATION, Air Intake Duct.>
6) Install the reservoir tank. <Ref. to CO(H4SO)-
27, INSTALLATION, Reservoir Tank.>
7) Connect the over flow hose.
8) Lift up the vehicle.
9) Connect the ATF cooler hoses. (AT model)
LU-02365
CO-00277
CO-00253