Subaru 2009 IMPREZA Service Manual page 355

Hide thumbs Also See for 2009 IMPREZA:

10) Connect the radiator outlet hose.

11) Connect the main fan motor assembly connec-

tor (A) and sub fan motor assembly connector (B).

12) Install the heat shield cover. (AT model)

Tightening torque:

3 N·m (0.3 kgf-m, 2.2 ft-lb)

13) Install the under cover.

14) Lower the vehicle.

15) Connect the ground cable to battery.

16) Fill engine coolant. <Ref. to CO(H4SO)-13,

FILLING OF ENGINE COOLANT, REPLACE-

MENT, Engine Coolant.>

17) Check the ATF level. (AT model) <Ref. to 4AT-

27, INSPECTION, Automatic Transmission Fluid.>

C: INSPECTION

1) Remove the radiator cap, fill the radiator with en-

gine coolant, and then install the tester to the instal-

lation position of cap.

2) Apply a pressure of 157 kPa (1.6 kg/cm

to the radiator and check the following points:

• Leakage from the radiator or its vicinity

• Leakage from the hose or its connections

• Engine should be turned off.

• Wipe engine coolant from check points in ad-

• Be careful of engine coolant from spurting

out when removing the tester.

• Be careful not to deform the filler neck of ra-

diator when installing and removing the tester.