Subaru 2009 IMPREZA Service Manual page 379

LUBRICATION
12) Remove the lifting device and wire ropes.
13) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
T2
14) Install the radiator upper brackets.
Tightening torque:
12 N·m (1.2 kgf-m, 8.9 ft-lb)
15) Install the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-13, INSTALLATION, Intercooler.>
16) Install the air intake boot. (Turbo model)
Oil Pan and Strainer
17) Install the air intake chamber. (Non-turbo mod-
el) <Ref. to IN(H4SO)-7, INSTALLATION, Air In-
take Chamber.>
18) Install the air intake duct. <Ref. to IN(H4SO)-8,
INSTALLATION, Air Intake Duct.> <Ref. to
IN(H4DOTC)-11,
Duct.>
19) Connect the connector to the mass air flow and
intake air temperature sensor. (Non-turbo model)
20) Connect the ground cable to battery.
LU-00222
21) Refill the engine oil. <Ref. to LU(H4SO)-9, IN-
T1
SPECTION, Engine Oil.>
C: INSPECTION
Visually check that the oil pan, oil strainer and baf-
fle plate are not damaged.
MT-00085
LU-02365
LU-02397
LU(H4SO)-18
INSTALLATION, Air
IN-00203
Intake