Clear Memory Mode - Subaru LEGACY 2003 Service Manual

10.Clear Memory Mode

A: OPERATION
1. WITHOUT SUBARU SELECT MONITOR
1) After calling up a diagnostic trouble code (DTC),
disconnect diagnosis connector terminal 8 from di-
agnosis terminal.
( 2 )
(1) Diagnosis connector
(2) Diagnosis terminal
(3) 8 terminal
(4) 5 terminal
Diagnostic trouble code (DTC) indication mode
ABS warning lamp
Terminal 8
NOTE:
After diagnostics is completed, make sure to clear memory. Make sure only start code (11) is shown after
memory is cleared.
2. WITH SUBARU SELECT MONITOR
Refer to SUBARU SELECT MONITOR for informa-
tion about how to clear diagnostic trouble codes
(DTCs). <Ref. to VDC-20, Subaru Select Monitor.>
CLEAR MEMORY MODE
( 1 )
( 3 )
( 4 )
VDC00136
Memory erase mode
GND(Low level)
2) Repeat 3 times within approx. 12 seconds; con-
necting and disconnecting terminal 8 and diagnosis
terminal for at least 0.2 seconds each time.
0.2 sec 0.2 sec or more
or more
12 sec or less
VDC-25
VDC (DIAGNOSTICS)
GND open (High level)
1.5 sec
VDC00138