Subaru 2009 IMPREZA Service Manual page 294

MECHANICAL
B: INSTALLATION
(1)
(7)
(1) Crankshaft bearing
(2) Crankshaft
(3) Cylinder block
1) Remove oil on the mating surface of cylinder
block before installation. Apply a coat of engine oil
to the bearing and crankshaft journal.
2) Position the crankshaft and O-ring on cylinder
block RH.
NOTE:
Use new O-rings.
Cylinder Block
(5)
(7)
(6)
(6)
(4) Rear oil seal
(5) O-ring
ME(H4SO)-76
(4)
(3)
(2)
3) Apply liquid gasket to the mating surfaces of cyl-
inder block RH, and position cylinder block LH.
NOTE:
• Install within 5 min. after applying liquid gasket.
• Do not allow liquid gasket to jut into O-ring
grooves, oil passages, bearing grooves, etc.
Liquid gasket:
THREE BOND 1217G (Part No. K0877Y0100)
or equivalent
(3)
(6) Seal washer
(7) Washer
ME-00145
ME-03186