Alignment Procedure - Christie Mirage S+/HD/WU User Manual

Section 2: Installation and Setup
7. Align the holes in the 3 stacking mounts and 3 stacking legs.
On each stacking mount, turn
the adjusting wheel slightly
until the hole in the top portion
of the mount lines up with the
hole in the stacking leg
2-15).
NOTE: You can increase leverage
by using a screwdriver in the holes.
8. Insert 3 safety pins and LOCK all.
At each of the 3 stacking points, insert the safety pin fully through the holes in the stacking mounts and
stacking legs
projectors together. Failure to engage the safety lock could cause the projectors to separate and result in
injury or death.
or death.
9. Leg Nuts.
Before hoisting, firmly tighten the nuts on the 2 rear stacking legs
the projectors to one another, leave these nuts slightly loose until after the alignment.
10. Repeat steps 1–9 if stacking a third projector.

2.2.4 Alignment Procedure

Stacked projectors must be correctly aligned to one another so that the resulting display is optimized and as
sharp as possible. If you are also hoisting the stack, hoist the stack into place first and then align. Lock all
stacking hardware into place to maintain your alignment.
IMPORTANT!
Figure 2-12.
Before You Begin
• Always align to the fixed projector. In floor-mount or table-mount (i.e., non-hoisted) stacks, you will align to
the bottom projector as shown in drawings below. In hoisted stacks, align to the top projector.
• Leg nuts must be loosened before alignment; otherwise the stacking mounts will not turn and allow move-
ment of the projector.
2-10
(Figure
Figure 2-15 Align Holes in Mounts and Legs, and LOCK with Pin
Critical Safety Procedure.
(Figure 2-15). Ensure that each pin is fully inserted to engage the safety lock and secure the
Failure to engage the safety lock could cause the projectors to separate and result in injury
Never stack more than 3 projectors.
Ensure the stacking legs are extended at least 1 inch and are slightly loosened. Refer to
(Figure 2-15). If you are ready to align
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)