Table of Contents
Advertisement
Section 3: Operation
NOTE: For more information, refer to the separate Using 3D in Mirage manual provided.
3D Stereo Sync Select
Define which of the Mirage 3D Stereo Sync Cable's input connecters is routed from your server. Use only if the
cable is present.
3D Stereo Sync Delay
Set when the L/R frames begin, defining the best reference point for synchronizing the display with your
glasses. Proper adjustment of this delay should eliminate cross talk and odd colors caused by timing
differences between the glasses and the projected display. Use this slidebar only if the Mirage 3D Stereo Sync
Cable is connected between the projector's GPIO port and a server. Slide bar values indicate the number of
lines that are delayed.
Frame Lock Enable
This option allows the projector to control the output frame timing based on the input
signal. The Locked option forces (if possible) the output image to be phase locked to the
input frames. Rate Matched means that the output runs at close to the input frequency ,
but is not locked to it so the output will drift in phase relative to the output. Free Run
forces the output to run at a 60Hz frame rate.
NOTE: For more information, refer to the separate Using 3D in Mirage manual provided.
Mirage HD/WU Series - Simulation 3D - Advanced Image Settings Submenu
From the Advanced Image Settings menu, use the
Simulation 3D submenu options to make timing
adjustments for realistic simulation environments.
Frame Delay Monitor
This slidebar monitors the latency between input and
output. For best results, the bar width and value should
remain fairly constant, indicating that timing of input and
output frames is locked; the Frame Delay Monitor value
should stay within 5-10 lines or so of the Frame Delay
setting. If a frame is lost or "dropped", the slidebar moves
suddenly and the values change, indicating that the frame
input is no longer equal to the output.
NOTE: For more information, refer to separate the Using 3D in Mirage manual provided.
3-40
Simulation 3D
Frame Delay Monitor
1.
Frame Delay
2.
Dark Interval
3.
3D Sync Input
4.
3D Sync Output
5.
3D Stereo Sync Delay
6.
Frame Lock Enable
7.
3D Source
Figure 3-26 Mirage HD/WU Models
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
1.
Locked
2.
Rate Matched
3.
Free Run
1047
1000
2500
Input A
To Emitter
592
Locked
020-100002-06 Rev. 1 (04-2011)
Advertisement
Table of Contents
