Rgb Signals - Christie Mirage S+/HD/WU User Manual

There are also several optional interfaces available for connecting other sources—these interfaces slide into the
remaining unused option slot, and can be done while the projector is running.
NOTES: 1) Refer to
shielded cables for all connections. 3) The Dual SD/HD-SDI module shown is standard on the
Roadster models, optional for the Matrix and Mirage series.

2.4.1 RGB Signals

consists of 5 BNCs (connectors) for linking to a variety of RGB sources such a PC, Mac, DEC, Sun,
INPUT 1
SGI, and others. This projector supports multiple Sync types with RGB signals: sync-on-green, composite
sync, and separate H & V syncs.
NOTE: Depending on your source, you may need a custom adapter cable with BNC connectors at the
projector end and a different type of connector at the other (such as a 15-pin "D" connector for some
computer sources). Contact your dealer for details.
Connect the
SYNC
and BNCs on the
BLUE
connections are required.
If the source provides a composite sync output, connect it to the
provides separate horizontal and vertical sync outputs, connect horizontal sync to the
and connect vertical sync to
COMP ,
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
Section 6 Specifications
Figure 2-27 Input Panel
BNC input(s) first. Then connect the red, green, and blue source outputs to the
panel. If the source uses sync-on-green, only the red, green, and blue
INPUT 1
input labeled
SYNC
for details regarding compatible inputs. 2) Only use high quality
Note:
Dual SD/HD-SDI Option Module shown.
Standard in Roadster S+16K/+12K, HD12K,
HD18K, S+20K projectors.
SYNC
See Figure
VERT.
Section 2: Installation and Setup
input labeled
HOR/COMP
input labeled
SYNC
2-28, below.
, ,
RED GREEN
. If the source
HOR/
2-19