Christie Mirage S+/HD/WU User Manual page 95

Frame Delay
Set the number of lines delayed between the input signal and its appearance on screen, keeping in mind that
projector processing always adds 1 frame of delay to the frame delay setting. For applications such as
simulation, where the feeling of "real time" image response is a priority, a minimum setting is usually
preferable. For projectors capable of 3D (stereographic) applications where alternating left-right frames must
be synchronized with the corresponding L/R shutters in 3D glasses, a total frame delay setting of 2 (or multiple
of 2) may be more useful. If set too high or low, frame locking will not be possible-most sources require
approximately 50 lines of delay to ensure frame locking.
AccuFrame
Increasing the AccuFrame value will reduce the artifacts related to fast motion in simulation content.
Symptoms of blurry objects or loss of apparent detail may indicate a need for this value to be adjusted.
NOTE: If increasing AccuFrame does not improve image quality, reduce the value to 0. Increasing
AccuFrame may increase 'flicker' of the display and may reduce overall brightness.
Frame Lock Enable
This option allows the projector to control the output frame timing based on the input signal. The Locked
option forces (if possible) the output image to be phase locked to the input frames. Rate Matched means that
the output runs at close to the input frequency , but is not locked to it so the output will drift in phase relative to
the output. Free Run forces the output to run at a 60Hz frame rate.
Reserved
No function.
Warp Latency
Requires optional Christie TWIST
module.
Advanced Image Settings Submenu
Motion Filter
This control is most useful for smoothing out moving images from interlaced sources. In most
cases the proper Motion Filter setting is automatically determined according to the type of
incoming source signal. However, if your source is noisy and/or inconsistent, you may wish to
"force" a setting to ensure stable processing for this source.
If desired, override the default "Auto" setting by selecting the appropriate motion filter:
Auto T
INCOMING SIGNAL
Still F
OR STATIC IMAGES WITH NO MOTION
Motion F
OR VIDEO IMAGES THAT DID NOT ORIGINATE FROM FILM
ATED IMAGES
Film F
OR VIDEO IMAGES THAT ORIGINATED FROM FILM
STABILITY
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
module. Refer to Christie TWIST
TM
HE PROJECTOR AUTOMATICALLY USES THE CORRECT MOTION FILTER ACCORDING TO THE
.
.
.
User's Manual provided with the
TM
,
SUCH AS GRAPHICS FROM A
,
OR FOR MOVING COMPUTER
. T
HIS WILL OPTIMIZE IMAGE QUALITY AND
Section 3: Operation
CD.
-
GENER
-
3-43