Power Cord And Attachments; Ventilation; Servicing - Christie Mirage S+/HD/WU User Manual

Section 4: Maintenance
4.3

Power Cord and Attachments

are using a line cord that meets the appropriate rating standards.
Only use attachments or accessories recommended by Christie, such as the specific power cord supplied. Use
of other attachments or accessories with this projector may result in the risk of fire, shock or personal injury.
cord are not within the specified voltage and power range. Refer to Section 6.
• Do not allow anything to rest on the power cord. Locate the projector where persons walking on it or objects
rolling over it cannot abuse the cord.
• Operate the projector at the specified voltage only. Do not overload power outlets and extension cords as this
can result in fire or shock hazards.
• The projector is equipped with a 3-wire plug having a third (grounding) pin. This is a safety feature. If you
are unable to insert the plug into the outlet, contact an electrician to have the outlet replaced. Do not defeat
the safety purpose of the grounding-type plug.

4.3.1 Ventilation

Slots and vents in the projector provide ventilation. Never block or cover these openings. This ensures reliable
operation of the projector and prevents overheating.
• Do not place the projector over a radiator or heat register. The projector should not be placed in an enclosure
unless proper ventilation is provided.
• Do not insert objects into the ventilation openings of the projector. They may touch dangerous voltages or
short-out components resulting in a fire or shock hazard. Do not spill liquids of any kind into the projector.
Should an accidental spill occur, immediately unplug the projector and have it serviced by a qualified service
technician.

4.3.2 Servicing

If any of the following conditions exist, immediately unplug the projector from the power outlet and refer
service to Christie accredited service personnel.
• The power cord has been damaged.
• The internal cooling fans do not come on within two minutes after the projector is first turned ON.
• Liquid has been spilled into the projector.
• The projector has been exposed to excessive moisture.
• The projector does not operate normally.
• The projector has been dropped or the case has been damaged.
• Projector performance has deteriorated.
4-2
The North American rated line cord is provided with each projector. Ensure that you
Use only the AC power cord supplied. Do not attempt operation if the AC supply and
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)