Christie Mirage S+/HD/WU User Manual page 140

Section 4: Maintenance
1. TURN THE LAMP OFF
Press
approximately 5 minutes) before proceeding with Step 2. This wait period is also required to allow the
lamp to sufficiently cool before handling.
2. UNPLUG THE PROJECTOR
When the cooling fans have stopped, turn the projector's main switch OFF, and unplug.
cool before handling
3. OPEN THE LAMP DOOR
Using a #2 Phillips screwdriver, loosen the ¼-turn lock screws
(2) securing the lamp door, which is located at the rear of the
projector below the Input panel. See
4. REMOVE LAMP RETAINING BAR
Remove the two (2) screws that secure the retaining bar along
the bottom edge of the lamp module using a #2 Phillips
screwdriver. See
the left.
4-6
(P ) to switch the lamp OFF. Allow the cooling fans to stop automatically (within
OWER
Always power down and unplug the projector prior to servicing. Allow the lamps to
Protective gear required. Wear a face shield.
Figure
Figure 4-3. Swing the bar aside-it is hinged on
Figure 4-3 Remove Retaining Bar
4-2.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
Figure 4-2 Open Lamp Door
020-100002-06 Rev. 1 (04-2011)