Table of Contents
Advertisement
2 Installation and Setup
This section explains how to install, connect and optimize the projector for delivery of superior image quality.
Illustrations are graphical representations only and are provided to enhance the understanding of the written
material.
2.1
Projector Quick Setup and Installation
The instructions provided here are for those that are familiar with the projector and wish to quickly set it up
and use it temporarily. Refer to the remaining subsections of this manual for a more complete setup.
cleaning.
2.1.1 QuickSetup
1. Install a Projection Lens.
The projection lens is shipped separately from the projector and must be installed prior to setting up the
projector. Install the projection lens as described in
debris from entering and settling on the projector's optical components.
2. Position the Projector.
Place the projector on a sturdy, level surface and position it so that it is perpendicular to the screen at a
suitable distance. In general, the further back the projector is positioned from the screen, the larger the
image will be.
If required, you can level the projector by adjusting its 3 feet. With the projector positioned perpendicular
to the screen the image will appear rectangular instead of keystoned.
For more detailed instructions on positioning the projector, refer to
Mounting
later in this section.
3. Connect a Source.
Located at the back of the projector is the input panel where all source connections are made. Each input is
clearly labeled for easy identification.
Using the appropriate cable(s), connect your source. Connect RGB and YPbPr sources to
in the upper right corner of the input panel. Use the DVI-I connector at
display signals. Connect composite video to
NOTE: One of the available optional input modules can be installed at
connections.
Refer to
Section 2.4 Connecting Sources
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)
Always power down the projector and disconnect all power sources before servicing or
Remove the lens plug from the lens opening in the projector before installing the lens.
Remove the lens when shipping the projector and reuse the lens plug to prevent dust and
for more details on connecting a specific source.
Section 4.8 Replacing the Projection
Section 2.3 Projector Position and
and S-video to
INPUT 3
Lens.
INPUT 1
to connect analog or digital
INPUT 2
.
INPUT 4
or
for additional
INPUT 5
INPUT 6
located
2-1
Advertisement
Table of Contents
