Christie Mirage S+/HD/WU User Manual page 71

new source is as large as possible without losing its aspect ratio. This and other default image settings depend
on the incoming source.
If you used the source once before and changed a display parameter such as Contrast, V-Position, etc.,
then a channel is automatically created and still exists in projector memory (see below).
Using an
Input
the display accordingly.
If more than 1 channel exists for the input, the image displays according to the setup parameters for the first
channel with matching characteristics.
If PIP is enabled, an input key changes the PIP (secondary) image only. To switch the main input, use the
keypad number keys with "Numbers Select Main Image" activated.
NOTE: Inputs 7 and 8 require the Dual SD/HD-SDI module in either of the projector's option slots. For their
selection, refer to
image, refer to
Channel
A Channel is a collection of measurements, locations and settings that tailor the display of a signal to your
specific needs. Since source types and applications can vary greatly, you likely want to adjust and define a
wide variety of parameters, such as Brightness, Contrast, Size, etc., in order to customize and optimize the
display from or for a particular source. For example, the display settings you choose for a VCR source may be
very different from those you choose for a high resolution computer source, or 1 signal may simply vary from
another signal used previously through the same input location. Once you have adjusted a display parameter,
such as pixel tracking or contrast, all current settings are collectively stored in the projector's memory as a
unique 2-digit Channel, such as "09".
You can have numerous distinct channels available for the same input, any of which can be selected by using
the key on the keypad, followed by the 2-digit channel number.
Chan
Shown above is a sample list of channels available when you press the
"Channel list".
NOTE: The
Chan
Channel List". Refer
In order to access channels by using the
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
key automatically recalls this channel (along with all associated setup parameters) and updates
Section 3.2 Using the
Section 3.7 Working with PIP or Seamless
Figure 3-11 Channel List
key may display a channel list or not, depending on what you have defined for "Display
toMenu Preferences
Keypads. For more information on numbers to select main
in Section 3.6.1 System Configuration (General
key on the remote, you must first create the channels.
Chan
Section 3: Operation
Switching.
key. This is typically called the
Chan
Settings).
3-19