Keypad And Remote Protocols And Conversion - Christie Mirage S+/HD/WU User Manual

Lens Offset
To move the image:
• If standard IR remote: Press either Lens H +
V +
See Figure
• If built-in keypad: Press

2.11 Keypad and Remote Protocols and Conversion

Both styles of remote IR keypads (ergonomic or "Brick" rental staging
Standard IR remote) can be converted to a wired remote by adding the
appropriate cable (provided, as shown in
simple applications in which it is impractical to communicate via IR, such as
when the projector is in another room and cannot respond to an IR signal (too
dark), or when you wish to connect to and control individual projectors within
a group.
To control the projector when signals from a remote cannot reach the projector, use the projector's rear built-in
keypad. The nearby LED display provides feedback indicating current status and activities of the projector.
Because the built-in keypad has fewer keys than the remote's keypad, certain projector functions are accessible
only through the Menu system rather than via a direct key press.
NOTE: The built-in keypad cannot be disabled.
In addition, the rental staging keypad typically used with Roadsters can operate under a variety of different IR
protocols, useful in multiple-projector sites where you prefer the tether-less freedom of controlling many
adjacent projectors independently. When keypad A operates under a different protocol than keypad B (or
others), each keypad communicates with the projector(s) having a matching protocol defined in memory only.
See below.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
or
2-46.
Lens
Shift
+ the Arrow keys. See
or
Figure 2-5
Figure 2-47). This is most useful for
Section 2: Installation and Setup
or Lens
Figure 2-45 Arrow Keypad
Figure 2-47 Sample Wired
Remote Cable
Lens
Shift
Figure 2-46
2-31