Table of Contents
Advertisement
3 Operation
This section describes the controls and switches used for basic projector operation once it is properly installed,
aligned and configured by a Christie accredited service technician. Please read through these pages before
using the projector for the first time. An understanding of projector features and how to access them will help
you to take full advantage of the capabilities of the projector within minutes.
NOTE: Installation involves locating the projector and adjusting it for use at that location. If you have not yet
installed the projector, refer to
3.1
Projector Basics
It is recommended that you read this section and familiarize yourself with the components and the available
menu options before you begin using your projector for the first time.
Projector components and functions are illustrated below
3.1.1 Zoom
Operated with the keypad, the internal optics of a motorized zoom lens rotates to adjust the size of the image
without moving the projector. Minimum and maximum image sizes depend on which zoom lens is installed.
Refer to
Section 6
3.1.2 Lens Release
Push lens release to enable the lens to be rotated for removal.
3.1.3 Focus
Operated with the keypad, focus adjusts the sharpness of the image at the current throw distance.
3.1.4 Lens Offset
Operated with the keypad, vertical and horizontal offsets shift the lens and move the image up or down and left
or right. Refer to
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)
Figure 3-1 Basic Projector Components (* on Roadster series only)
Specifications.
Section 2 Installation and Setup
Section 2 Installation and
(Figure
and
Section 6 Specifications
Setup.
3-1).
for ranges and other details.
3-1
Advertisement
Table of Contents
