Filter Replacement Procedure - Christie Mirage S+/HD/WU User Manual

IMPORTANT!
therefore be inaccurate. The lamp life limit may then expire prematurely.

4.7.1 Filter Replacement Procedure

The filter located at the front side of the projector should be replaced whenever the lamp is replaced. If you are
working in an extremely dusty environment you may want to replace the filter sooner. Use the filter provided
in the Christie approved Lamp and Filter Kit for your specific projector model (refer to
1. TURN OFF THE PROJECTOR, COOL AND UNPLUG.
Before removing or installing a filter, turn OFF the projector and allow it to cool for 5 minutes before
unplugging.
2. REMOVE FILTER DOOR .
Loosen the ¼-turn screw at the top of the filter grille/
door. Lift the door away from the projector. See
4-8.
NOTE: In the Roadster S+20K/HD18K & Mirage HD18/
WU18/S+20K, also remove the triangular metal
filter brace.
3. REPLACE FILTER .
Remove the old filter and insert the new one. Follow the airflow
arrows for correct orientation. See
S+20K/HD18K & Mirage HD18/WU18/S+20K, which has a
rhomboid-shaped filter, insert the sharply angled corner first -
place fully back on the left. Ensure the triangular metal filter brace
is installed after the filter has been positioned. See
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
If you neglect to enter a serial number, the lamp timer will not reset to "0" and will
Use Christie approved filters ONLY.
Figure
Figure
4-9. In the Roadster
Figure 4-10.
Section 4: Maintenance
Table 4.2).
Figure 4-8 Remove Filter Door
Figure 4-9 Remove Lamp Module
4-9