Christie Mirage S+/HD/WU User Manual page 62

Section 3: Operation
Input 6
Input 6
Press the
enabled, press INPUT 6 to assign it as the PIP source. If the Dual SD/HD-SDI Module is installed here, and
there are two inputs connected, its second input (B) is considered INPUT 8. Or, if you are using the built-in
keypad or the remote keypad, neither of which have a separate
follows:
• While displaying from INPUT 6, press
• While displaying from any input other than the Dual SD/HD-SDI Module, press
either INPUT 6 or INPUT 8, depending on which of the Dual SD/HD-SDI Module inputs (A or B) was last
used. Press
Input 6
Input (Standard IR Remote Only)
Input n
Enter (where
source to display. The 6 source locations are identified with Input numbers on the projector's Input panel. The
last two, 7 and 8, require the Dual SD/HD-SDI Module be installed in either of the option slots.
If PIP is enabled,
(primary) image source.
Key behavior depends on whether or not the Display Channel List option is selected in the Menu
NOTE:
Preferences menu. You can choose to have on-screen feedback when you press , or you may prefer to
enter the desired source location "blind", i.e. without on-screen feedback. Refer
in Section 3.6.1 System Configuration (General
Brightness
Press to increase or decrease the amount of black in the image. Use the
Bright
reach the desired level of contrast. For best results, start high and decrease so that dark areas do not become
black (i.e., "crushed"). Conversely, overly high brightness changes black to dark gray, causing washed-out
images. Refer to
NOTE: Always adjust Brightness before Contrast.
Contrast
Press to change the amount of white in your images. Use the
Contr ast
desired level of contrast. For best results, start low and increase so that whites remain bright, but are not
distorted or tinted, and that light areas do not become white (i.e., "crushed"). Conversely, low contrast causes
dim images. Refer to
Gamma
G am m a
NOTE: This is the same as "Gamma" in the Image Settings menu.
"Gamma" determines what gray shades are displayed between minimum input (black) and maximum input
(white) for a given amount of signal. The proper setting helps maintain optimized blacks and whites while
ensuring a smooth transition for the "in-between" values utilized in colors and grays. Thus, unlike brightness
3-10
key to display from the INPUT 6 interface module installed in the Option 2 slot. If PIP is
again to display from the other Dual SD/HD-SDI Module input.
n
= 1, 2, 3, 4, 5, 6; 7 and 8 are optional) as an alternative method for selecting which
Input n changes the PIP (secondary) image source, and
Section 3.5.3 Image Settings
Section 3.5.3 Image Settings
Input
Input 6
again to switch to INPUT 8.
Settings).
Menu.
Menu.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
key, press INPUT 6 to access INPUT 8 as
. This switches to
Input 6
Input PIP n changes the main
toMenu Preferences
and
and keys until you reach the
020-100002-06 Rev. 1 (04-2011)
keys until you